L1 Model II

Let's talk about the L1® Portable Line Array Systems

Using proprietary Bose® technology, L1 systems combine  PA and monitors into a single, highly portable unit. The  loudspeaker can be positioned behind or to the side —and you hear what the audience hears.

Highly portable PA and monitor combined for solo performers, DJs and general-purpose use. Fixed vertical control with 180° horizontal coverage Reduced vulnerability to feedback.

Three systems to choose from (Compact, Model 1S, Model II)
Two passive bass module options (B1 or B2)
Consistent coverage and tonal balance, portability and easy setup.

Replacement feet for Model II base??

Hello Marty,

Welcome to the forum.

I removed a nearly new foot from a Model II. The measurements are as follows:
Diameter 1-3/16" X height 3/8" (30mm X 9.6mm)

The maximum height of 3/8" (9.6mm) for the feet is important for stability; it is not recommended to use thicker feet because the ends of the fold out legs would be raised off of the floor

The recesses where the feet are installed will not accept a larger diameter than the original feet but 1" (25.4mm) should work fine.

I did a bit of research for you for some possible replacement feet:

Penn Elcom F1690

Keystone Electronics 723 DigiKey

MojoTone Rubber Feet, 25.4X9.5mm

This type of feet are commonly used under guitar amp cabinets, it's a matter of finding some of the correct height and of a diameter that will fit. These need to have a steel washer for the mounting screw.

This should help you find suitable replacement feet.

Add Reply

Likes (0)
Having trouble signing in?

We recently updated our sign-in procedure and if you have old sign-in data cached, this can create a problem. Please:

  1. Clear your browser cache and cookies
  2. Then close the browser (not just the window)
  3. Open the browser and try again
Thank you

Please make sure that your profile is up to date
×
×
×
×